John Deere 70 - Power Block

This is a power block that has been work on. Between the arrows is where it was cut out so the sleeves could be press out. The shop made a plate with tabs that could be moved out and put in the cut area so the sleeves could be press out. A boring bar machine was used to do the cutting. A 1/4' ring was then put in the area that was cut out when it was put back together with sealer between them. The reason I had mine out was to replace the o-rings around the sleeves. It was leaking water in the cylinder. The guy said if he would do it again it would be 1500. to do it. That was 4 years ago. Submitted by Phil Foutz, from OH